Monsoon season means traffic congestion and soggy roads. What if your bike is stuck in the middle of the road during heavy rain? It could be a tense moment. Most riders panic and forcefully attempt to start the bike, which does more harm than good. Here’s what you should not do instead.
Don’t Try to Start the Bike Again
If your bicycle malfunctions while driving over an inundated road, the one thing to note is not to restart it. Water could have penetrated vulnerable components such as the exhaust, engine, wheel bearings, or even the electrical components. Re-starting it could lead to further damage, including breakdown in essential electrical components.
Remove the Spark Plug Immediately
Rain often brings along mud, which can damage the threads of your bike’s spark plug. If the spark plug is left unattended for too long in wet conditions, dirt may accumulate around it. Later, removing it becomes harder, and the chances of damaging the plug increase. That’s why it’s better to remove it immediately after the bike stops in water.
Disconnect the Bike’s Battery
The battery is the most vulnerable component where rain-related problems are concerned. When your bike dies in water, immediately remove the battery. This will stop electrical circuits from being damaged as well as prevent short circuits. This will save you costly repairs.
Drain Water by Tilting the Bike
If water has gone inside your bike, lean it slightly to both sides. This aids in draining water from inside compartments. You can also use common tools from your toolkit to open certain parts and drain the water better. Don’t keep the bike wet, or it can cause rust and long-term damage.
Avoid Delays in Cleaning and Drying
After safely bringing your bike out of water, don’t wait for the next day to clean it. Dry it off properly and make sure all water is removed from key components. Taking quick action helps keep rust, electrical issues, and other damage in check.
Also Read: Big relief in summer this car AC feature saves you from ₹10000 in repairs know how